This card was made for Auntie T's January Card Challenge. This card was made for the "metal" category. TFL!!
The tool belt was hand made and faux stitched using a piercing tool and a zig pen.
How to make the tool belt:
Gather a small piece of textured card stock or the size required to fit your card proportionately.
Wet the card stock evenly on both sides-do not over satuate the cs.
Gentle crumple the cs, and dry excess water with a paper towel.
Gently uncrumple the cs and iron the cs until dry- this will give the cs a worn leather look.
This tool belt is only three pieces, so just cut as shown and piece together.
Sorry I bought the metal tools charms about two years ago and I took them out the package so I don't know who made them nor can I remember where I bought them but I know eyeleyout sells tool brads that would work just the same.