This card was made for Auntie T's January Card Challenge. This card was made for the "metal" category. TFL!! The tool belt was hand made and faux stitched using a piercing tool and a zig pen. How to make the tool belt: Gather a small piece of textured card stock or the size required to fit your card proportionately. Wet the card stock evenly on both sides-do not over satuate the cs. Gentle crumple the cs, and dry excess water with a paper towel. Gently uncrumple the cs and iron the cs until dry- this will give the cs a worn leather look. This tool belt is only three pieces, so just cut as shown and piece together. Sorry I bought the metal tools charms about two years ago and I took them out the package so I don't know who made them nor can I remember where I bought them but I know eyeleyout sells tool brads that would work just the same.
Does this project or one of it's images contain pornography, profanity, or other illegal or offensive material? If so, please report it and our moderators will come by and clean it up in a flash.
January 28, 2011
January 21, 2011
January 17, 2011
January 17, 2011
January 17, 2011
January 15, 2011
January 15, 2011
January 14, 2011
January 12, 2011
January 07, 2011
January 06, 2011
January 05, 2011
January 04, 2011
January 04, 2011
January 03, 2011
January 03, 2011
January 03, 2011
January 03, 2011
January 03, 2011
January 03, 2011
January 03, 2011
January 03, 2011
January 03, 2011
January 03, 2011